If you're looking for a simple solution to add LEDs to your drone look no further!
No wires no mess, just direct solder to your XT60 connector and you're good to go.
Available in 5 colors and 2 variants (LED Only and LED with capacitor slots)

Remember to pick up our Clear XT60 connectors to make them glow with these leds!

Checkout our LED section as well as our Soldering related gear!

Note:
We have found the purple color to be significantly weaker than the rest of the colors to where we didn't even feel good listing them, but if you are really looking for purple you can give them a try.

Tip:

Our 20mm Clear Heatshrink work great with this setup!
13mm heatshrink (with little streching) works with the NON Capacitor Led setup

Features:

Super lightweight
Easy and Clean to install
No additional wires needed
4 to 6S power (Brighter as cell numbers go up but 4S is already pretty bright)

Includes:

1 x Pyro-Led

Batteries and Connectors

XT60 Pyro-Led by Pyrodrone - 4-6S

Pyrodrone Clear XT60 Connector Male (device) - 5 Pack

JST-XH 2-6s Balance Board